64
8. Disassembly Procedure
1.
Take out the monitor from the HDPE bag and put the monitor
on a protective cushion. Use a Phillips-head screwdriver to
remove the four screws to unlock the stand.
2.
Use a small slot screwdriver to insert between the two gaps
(marked as No.1~2) on the bottom side of the rear cover
to pry up the rear cover. Use one hand to press the panel
module, the other hand to pull up the rear cover in order of
arrow reference for unlocking the mechanisms of the rear
cover. Remove the rear cover.
3.
Put the rear cover on a protective cushion, tear off the mylar
tape, then use a Phillips-head screwdriver to remove 3
screws to release the function key board.
4
Use a Phillips-head screwdriver to remove 18 screws to
unlock the middle frame with the panel module, then remove
the middle bezel.
5
Tear off 3 aluminum foil pieces to release the bracket from
the panel module. Disconnect the panel power cables from
the connectors of the panel model by tearing off the adhesive
tape stuck on the back of the cables.
6
Tear off the adhesive tape stuck on the back of the LVDS
cables, push the earring-lock, and remove the LVDS cables
from the connector of the panel module.
7.
Lift up the bracket chassis module and put it on a protective
cushion, then use a Phillips-head screwdriver to remove two
screws for unlocking the AC power outlet.
8.
Release the two speakers from the speaker holders, then
release the speakers' cable from the hooks of the bracket
chassis module.