13
Remote Control Effective Range
To ensure proper function of the remote control
follow the steps below:
1.
The remote control must be held at an angle
within 30° perpendicular to the projector’s IR
remote control sensor(s).
2.
The distance between the remote control and
the sensor(s) should not exceed 8 m (26 ft.)
NOTE:
Refer to the illustration for the location of
the infrared (IR) remote control sensor(s).
Approx. 30°
Replacing the Remote Control Batteries
1.
Remove the battery cover from the rear of the remote control by pressing the
finger grip and sliding it down.
2.
Remove any existing batteries (if necessary) and install two AAA batteries.
NOTE:
Observe the battery’s polarities as indicated.
3.
Replace the battery cover by aligning it with the base and pushing it back into
position.
NOTE:
•
Avoid leaving the remote control and batteries in excessive heat or a humid
environment.
•
Replace only with the same or equivalent type recommended by the battery
manufacturer.
•
Dispose of the used batteries according to the manufacturer’s instructions and
local environment regulations for your region.
•
If the batteries are drained or if you will not be using the remote control for an
extended period of time, remove the batteries to avoid damage to the remote
control.
