Turning the TV On and Off
Press the
POWER
button on the remote control.
You can also use the
POWER
button on the front of the
panel.
Operation
Initial Setup
1. Press the POWER button on the remote control. The Setup Wizard window will be
displayed.
2. Press ▲ or ▼ to select OSD language, then press ENTER to confirm the selection and
enter next step. To cancel the selection, press MENU. To return to the previous page, press
RETURN. (see Figure 1)
3. Select Clock Mode from Auto or Manual, then press ENTER to continue. (see Figure 2)
4. Select Time Zone of your location, then press ENTER to continue. (see Figure 3)
5. Select TV RF source from Air or Cable, then press ENTER to continue. (see Figure 4)
6. Check if RF cable is connected properly then press ENTER to perform Channel scanning.
(see Figure 5)
7. The Initial Setup will be completed after Channel scanning is finished. To interrupt the
scanning, press MENU at any time. (see Figure 6)
Figure 1
Figure 2
Figure 3
Figure 4 Figure 5 Figure 6
ViewSonic Corporation
Confidential - Do Not Copy
N4285p-4M
14
Summary of Contents for N4285p-4M
