ViewSat VS2000 ULTRA, User Manual

Page: 10 / 21

16
17
1.A. ANTENNA SETUP
Your receiver includes the preprogrammed information of transponders contained in various
satellites.
You can update the transponder list preprogrammed
for a satellite by adding a new transponder to it or
modifying the information of the existing transponder.
(Refer to the Channel Scan described in section 1.B)
Select
“ Antenna Setup ” menu in “ Installation ” menu
and the following screen will be displayed.
Select the desired satellite using the
“
left/right
”
keys( ◀∙▶ ). Set
“
LNB Power
”
,
“
LNB Type
”
,
“
LNB
Freq ” , “ 22KHz ” , and “ DiSEqC 1.0 ” fields to the
appropriate value using the left/right keys( ◀∙▶ ) at
each field.
LNB Power
LNB Type
LNB Freq.
22KHz
DiSEqC 1.0
Motor
: Depending on the user ’ s antenna LNB, you can supply either LNB power by
setting “ ON ” or not by setting “ OFF ” . Normally set this to “ ON ” .
: You can select the LNB type.
: You can select the predefined LNB frequency or manually enter a specific
frequency in MHz unit by pressing numeric keys.
: In case you are using two antennas connected to a 22KHz tone switch box,
you can supply either 22KHz by setting
“
ON
”
or off by setting
“
OFF
”
to select
antenna.
: If you have DiSEqC box, you can choose port by selecting port number.
Otherwise, choose
“
none
” .
: If you have a DiSEqC 1.2 motorised system, then you can take advantage of the
DiSEqC 1.2 functions available. Choose Installer as Motor and press “OK” key.
After that, adjust antenna direction using browse keys.
1. B. 1 Channel Scan
Select the desired satellite using the “ left/right ” keys (
◀∙▶
).
Select the “ Antenna Configuration ” icon using the browse keys(
▲∙▼ ,◀∙▶
).
Press “ OK ” key, and set “ LNB Power ” , “ LNB
Type ” ,“ LNB Freq ” , “ 22KHz ” , and “ DiSEqC 1.0 ”
fields to the appropriate value using the “ left/right ”
keys( ◀∙▶ ) at each field. Check the signal strength
and press
“
Exit
”
key.
Select the “ Search/Edit TP ” icon using the “ left/right ”
keys(
◀∙▶
). Press “ OK ” key, and select the
desired transponder using the “ up/down ” keys (
▲∙
▼
). Press “ OK ” key to start the manual searching for
selected transponder.
1. B. CHANNEL SCAN
It will be more convenient to use “ Channel Scan ” procedure when you want to search
channel for a specified transponder offered from the satellite. As in “ Antenna Setup ” ,
“ Channel Scan ” also searches all channels broadcasted over a specific transponder
using its predefined information. You can add a new transponder if you cannot find it on
the predefined transponder list.
Select
“ Channel Scan ” menu in “ Installation ” menu, and the following screen will be
displayed.
1. A. 1 USALS
Please go to Antenna Setup and select USALS
from motor.
Press the “OK” key then Pop-up will be appeared.
Press arrow button to write Longitude
Press arrow button to write Latitude, then OK to
work.