Niagara 4100 User Guide
ViewCast
33
Checking CPU usage
When the Niagara 4100 is idle (no encoders are streaming), the CPU percentage is normally 4 % or less.
If one or more encoders are streaming, the percentage is much higher and fluctuates in a range of +/- 10
%. If the system is using less than 80 %, you may start another encoder without adversely affecting
system performance (depending on the complexity of the profile).
To check CPU usage:
1.
Press
Menu
. The system menu appears.
2.
Use the
Up
and
Down
arrow buttons to select
Access Health
.
3.
Press
Enter
. The access menu appears (Figure 28).
Figure 28. Access menu
4.
Use the
Up
and
Down
arrow buttons to select CPU.
5.
Press
Enter
. A screen appears (Figure 29) with the amount of CPU cycles currently in use.
Figure 29. CPU cycles screen
6.
Press
Enter
.
Summary of Contents for Niagara 4100
