Version: 3:0
KEN002DH 24.02.2021
[ EN
●
10 ]
WARNING
●
For safety reason, please use only the same size of fixing or mounting screw which
are recommended in this instruction manual.
●
Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
● Keep exhaust duct short and straight
● Do not reduce the size or restrict exhaust duct
● When using flexible duct always install the duct pulled taut to minimize pressure loss
● Failure to observe these basic instructions will reduce the performance and increase noise levels of the
cooker hood.
● Any installation work must be carried out by a qualified electrician or competent person.
● Do not connect the ducting system of the hood to any existing ventilation system which is being used for any
other appliance ,such as warmer tube, gas tube , hot wind tube.
● The angle of the bend of the ventilation pipe should not be less than 120º; you must direct the pipe horizon
-
tally, or, alternatively, the pipe should go up from the initial point and should be led to an outer wall.
● After the installation ,make sure that the cooker hood is level to avoid grease collection at on end.