3
1. Important information
Please read this manual completely and attentively before us-
ing the product for the first time. Keep this manual. It is part of
the product.
1.1 Safety instructions
Caution:
Risk of injury!
Tools are required for installation.
Electrical hazard!
Never put the connecting wires into a power socket! Regularly
examine the transformer for damage. In case of any damage,
do not use the transformer.
Make sure that the power supply is switched off when you
mount the device and connect the cables!
Only use VDE/EN tested special model train transformers
for the power supply!
The power sources must be protected to avoid the risk of
burning cables.
1.2 Using the product for its correct purpose
This product is intended:
- For installation in model train layouts and dioramas.
- For connection to an authorized model train transformer
(e. g. item 5200).
- For operation in dry rooms only.
Using the product for any other purpose is not approved and is
considered inappropriate. The manufacturer is not responsible
for any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
- H0 DB Ticket machine with LED lighting
- Manual
2. Introduction
This LED model uses SMD LEDs to produce light matching the
lamp model. Low heat build-up and power input. Nearly unlimited
lifetime of the LEDs, so no more change is required.
3. Mounting
- Remove the LED model carefully from the package.
- Check function before mounting.
- Drill a hole (Ø 2 mm) at the mounting place (see fig. 1).
- Slide the connection cables through the hole.
- Put the machine at the desired spot and, if desired, fix it in
place with a little adhesive.
4. Connection
Caution:
Resistor and diode at the cables are needed for proper func-
tion of the LED model. Never cut them off! Never cover resis-
tor or diode with insulation material, because they have to be
cooled by surrounding air!
While connecting the cables, leave a loop of about 2 – 3 cm
length below the LED model, so that you can pull and reverse
the LED model from the mounting place during any work.
Connect the LED model to the lighting power output of a model
train transformer (e. g. item 5200) or power supply as shown
in fig. 2 and/or 3.
DC voltage:
Connect the diode (red part with black mark)
with the plus pole of the power supply, the resistor with the mi-
nus pole.
AC voltage:
Operation with AC voltage could cause some flickering.
We recommend to use the Viessmann power module, item 5215,
which is sufficient for ca. 100 LED lamps or reflectors (fig. 3). Connect
the cable to the diode with the brown output socket, the resistor with
the red output socket of the power module.
5. Warranty
Each model is tested to its full functionality prior to delivery. The
warranty period is 2 years starting from the date of purchase.
Should a fault occur during this period please contact our ser-
EN