Remove clamping ring and push floor piece in by two rings
(2 x 10 mm).
Align the floor in such a way that the arrows point towards the drain
pipe.
Secure floor with clamping ring.
Tighten the screw of the clamping ring with max. 2.5 Nm ±0.2 Nm.
Alternatively, tighten the end of the clamping ring up to or between
the markings.
ð
The water seal level is 35 mm and the immersion pipe length
33 mm.
3.2.2
Mount base unit
A few points must be observed to integrate the drain into the floor con-
struction properly. For this reason, proceed as follows to prepare the
drain for subsequent work:
Handling
Advantix Top bathroom drain
18 from 26