When the roller head has not touched the press jaw yet and no pressing
force has been built up, simply let go of the Start button to abort
pressing.
Next, actuate the button for manual unlocking and move the roller head
back to the starting position.
After the machine has started the automatic process, pressing can only
be aborted by actuating the button for manual unlocking.
3.4
Troubleshooting
In case of malfunction, check the following potential causes:
Malfunction
Cause
Remedy
Actuating the Start
button does not
trigger pressing.
The press machine is
not switched on.
Press the On / Off
button. The green
LED is lit.
The battery is too
weak.
Fully charge the bat-
tery.
The battery or power
pack is not properly
inserted.
Check that it is prop-
erly inserted in the
mounting bracket.
The mains cable of
the power pack is not
connected to the
mains.
Connect it to the
power supply.
The power supply is
not correct.
Establish the power
supply as specified by
the manufacturer.
If the press machine does not start up after taking the above-named
measures, please contact an authorised service point (
Ä
Chapter 3.6
„Service partners“ on page 20).
3.5
Care and maintenance
3.5.1
Cleaning
NOTICE!
Damage due to fluids
Make sure that no fluids get inside the press machine.
Never dip the press machine into fluids.
Aborting the pressing process
Press machine
Handling
Pressgun Picco press machine set
18 from 22
