Loosen the fixing screws and remove the cover of the casing.
Break off the pre-cut cable inlet in the area of the connection ter-
minal at the bottom of the casing.
Insert the strain relief device provided by the customer.
Connect the leads of the cable pursuant to the terminal diagram.
Close the casing cover.
NOTICE!
Optionally, you can transmit the signal of the room thermo-
stat to two other actuators (terminal 2 and/or 5) at terminal 1
and/or 4. In this case, one thermostat each in total can be
used.
Break off the pre-cut cable inlet in the area of the connection ter-
minal at the bottom of the casing.
Insert the strain relief device provided by the customer.
Connect the leads of the cable pursuant to the terminal diagram.
Close the casing cover.
Assigning two actuators to one RT
Assigning four actuators to one RT
Handling
Basic unit 24 V
with pump module
13 from 17
