Vido WD010611400, Instruction Manual

Page: 12 / 16

1400W ANGLE POLISHER ENG
turned in the direction of 6. And lower speed is obtained when it is turned in the direction of 1 (See Fig
7). The required speed depends on the material and the working conditions and can be determined
through practical testing.
7. Polishing and sanding operations
Hold your power tool with one hand on the rear handle and other hand firmly around the auxiliary
handle. Turn the power tool on and then apply the polishing bonnet to the workpiece (See Fig 8).
Always maintain an angle between the polishing bonnet and work surface of approximately 15
o
when
polishing (See Fig 9
12
) or maintain an angle between the sanding disc and work surface of approximately
10
o
when sanding. Apply slight pressure only. Excessive pressure will result in poor performance and
premature wear to polishing bonnet.
Warning: Never use tools with the Max specified rotational/circumferential speed on the
label of the tools smaller than the values given in the nameplate of power tool.
WORKING HINTS FOR YOUR POWER TOOL
1. Use caution when working into corners as contact with the intersecting surface may cause the
power tool to jump or twist.
2. At all times, let the power tool do the work, do not force it or apply excessive pressure to the tools.
3. For the polishing of weathered paint or buffing out scratches (e.g., acrylic glass), the power tool may
be fitted with appropriate polishing accessories such as lamb’s wool bonnet, polishing felt or sponge
(optional accessories). Select a low speed for polishing in order to avoid excessive heating of the
surface.
4. Do not allow the polishing agent to dry out on the surface. Otherwise the surface can become
damaged. Do not subject the surface to be polished to direct sunlight.
5. When sanding guide the sanding disc with crosswise strokes. Do not use a circular motion, as this
makes swirl marks. Test before use on scrap stock.
6. For sanding applications on soft materials, e. g., gypsum or paint, it is recommended to use the
rubber sanding plate with sanding sheet. Cup brushes and wheel brushes are suitable for rust removal.
MAINTENANCE
Warning: Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
1. Keep the power tool ventilation slots clean and free from obstructions. If available, blow compressed
air into the vents to clear any internal dust (safety goggles must be worn when undertaking this
process).
2. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth.
3.Clean the polishing accessories regularly to ensure good polishing results. Wash out polishing
accessories with mild detergents and warm water. Do not use solvents.
4. Your power tool requires no additional lubrication.
5. Always store your power tool in a dry place.
6. If you see some sparks flashing in the ventilation slots, this is normal and will not damage your power
tool.
7. The motor employs carbon brushes which are consumable parts. Since an excessively worn carbon