Vidikron DView VL-52, Owner'S Operating Manual, Page: 63 / 76

Vidikron VL-52 and VL-57 Owner’s Operating Manual 51
PRE
L
IMINAR
Y
6.1
RS-232 Connection and
Port Configuration To interface the DView with a home theater automation/control system or a PC running
terminal emulation software, connect it to your control system or PC as shown in Figure 3-10.
(Use a straight-through cable.)
Configure the RS-232 controller or PC serial port as follows: no parity, 8 data bits, 1 stop bit
and no flow control. Set the baud rate to match that of the DView RS-232 port. To check the
baud rate setting, select Baud Rate from the ISF Calibration menu (refer to page 41).
6.2
Serial Command Syntax • Commands are in ASCII format and are not case-sensitive.
• A carriage return is not required after a command.
• When you send a valid command, the DView executes it and acknowledges it with a
right-bracket character (
]
) followed by the four-digit numeric code you sent; for example,
]0002
.
• When you send an invalid command (one followed by values outside the valid range for
that command), the DView ignores it and returns
>MAX
or
<MIN
instead of the four-digit
code.
• When you send an unrecognized/misspelled command, the DView ignores it and returns
-N/A
instead of the four-digit code.
Table 6-1 lists the RS-232 command set.
6
Serial Communications
Table 6-1. Serial Commands
Command Description
[ S3A 0###
Set audio volume to ### ( = 000-100)
Example: [S3A0075 sets volume to 75
[ +3A
Audio volume up
[ -3A
Audio volume down
[ S3E 000#
Audio mute (speakers/headphones)
0 = not muted, 1 = muted
Example:
[S3E0001
mutes the audio output
[ S4A 000#
Main input selection
0 = TV
1 = Input1
2 = Input2
3 = Input3
4 = Input4
6 = RGB
8 = HDMI1
9 = HDMI2
Example:
[S4A0006
selects RGB
[ +4A
Select “next” Main AV input