Videx VX2300, Installation Handbook

Page: 61 / 100

67009600-EN - Edition 2015 - Rev. 1.0
61
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
SURFACE MOUNTING INSTRUCTIONS
135cm
Fig. 7 Fig. 8
Fig. 9
2
2
1
1
Fig. 10 Fig. 11
1. First of all remove the back cover as described on the previous page;
2. As shown in
Fig. 7
, place the videointercom back cover against the wall at 135cm height from the floor and mark the fixing holes.
Make the holes (5mm diameter) and insert the provided wall plugs as shown in
Fig. 8
;
3. As shown in figure
Fig. 9
, fix the back cover of the videophone to the wall keeping the same orientation shown in the figure and
taking care to feed the connection cables through the specific circular opening;
4. Connect the wires using a flat screw driver then setup the dip-switches as per provided connection diagram or instruction sheet
and fix the front part of the videophone to the back cover as shown in
Fig. 10
: hook first the bottom side then rotate the front
part and hook the upper side;
In order to avoid malfunctions, please do not over tighten the screws.
5. The video intercom is installed ( Fig. 11 ), power up the system and check that it works correctly.
Kristallo Series
7" flush and surface videomonitor wall mounting instructions