Videx VRVK-1/6758, Installation Handbook

Page: 20 / 32

66250705-EN - V5.1 - 30/09/20
- 20 -
VRVK/6758 Series “6 wire Bus” Vandal Resistant videokit
VRVK/6758 Series - Installation handbook
6700 Series
Wall mounting instructions
1
2
A
A
Fig. 1 Fig. 2
135cm
Fig. 3
B
B
C
C
D
D
E
G
G
Fig. 4 Fig. 5 Fig. 6
2
1
Fig. 7
1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base:
insert a 5.5mm fl at screw driver into the clip
A
then rotate clockwise until you listen a “CLICK!”.
Repeat the same operation with the other clip as shown in Fig. 1 .
2. Pull outwards the left part of the cover as shown in Fig. 2 . Don’t pull the cover straight .
3. Put the base of the unit on the wall at approx 135cm from the fi nished fl oor ( Fig. 3 ) to match the points for the fi xing holes B
( Fig. 4 ) remembering that the wires E ( Fig. 4 ) must be fed through the large hole F ( Fig. 4 ). If you use the fl ush mounting box
503, embed it into the wall vertically at approx. 140cm from the fi nished fl oor and the base.
4. Following Fig. 4 , make the holes B , insert the wall plugs C and fi x the base with the screws D feeding the wires E through
the hole F . If you have used the box 503, fi x the base to the wall through the holes G using the screws D .
5. As shown in Fig. 5 , connect the wires to the removable terminals following the provided installation diagram. Connect the terminal
blocks to the electronics contained in the cover as shown in Fig. 6 . Test system before closing.
Contrast and hue trimmers can be adjusted only if the videophone is open. To activate the display and see changes use the
“Camera Recall” function by pressing
button .
Note: while testing the system, it is advisable to hold the cover with your hand.
6. Once testing is complete and all the necessary adjustments are made, close the unit as shown in Fig. 7 : fi rst hook in the right
part and then the left part until you hear a “CLICK!”.