Videx IP videokit IPVK/6296 Series, Installation Handbook

Page: 8 / 76

66550062-EN - V6.0 - 31/10/21
- 8 -
IPVK/6296 Series IP videokit
IPVK/6296 Series - Installation handbook
ENABLE BOOTLOADER MODE
In case of firmware update failure (i.e. because of mains failure or cable disconnec-
tion during the update etc.) and the door panel is no longer recognised by the Videx
IP Wizard software, you can try to restore it by manually putting it into boot mode.
It is strongly recommended that this operation is carried out by a qualified engineer
and in any case after a contact with Videx support.
• Disconnect the door panel from the power supply.
• Press and keep pressed the
I
button (
Fig. 2 on page 5
) then connect again
the power supply source.
• The door panel will go into boot mode which is indicated by the four LED’s
flashing alternatively (
Fig. 13
).
• Now proceed using the utility “VidexFirmwareUpdater.exe” to upload the
firmware to the device.
• If the update process terminates correctly, the device should be restored and ready to work.
• If the device still does not work, please contact the supplier to proceed according to the warranty terms.
CAMERA NOTES
MAXIMUM ILLUMINATION DISTANCE
FROM CAMERA AT NIGHT
The illumination LED’s within the camera
will illuminate the visitor when they are
within 50 cm of the camera.
MAX 50 cm
FIELDS OF VIEW
The fields of view for standard camera are 55° for vertical angle and 115° for horizontal angle
while for Wide Angle camera are 80° for vertical angle and 170° for horizontal angle.
195 cm
80° 55°
170 cm
100 cm
75 cm
135 cm
70 cm
Vertical angle
170°
115°
180 cm
105 cm
70 cm
Horizontal angle
Standard camera Wide Angle camera
ADHESIVE GASKET PLACEMENT
Apply the
Y
seal as shown in
Fig. 14
.
ANTI-TAMPERING LOCKS FIXING
Fit the anti-tampering locks
W
as shown in
Fig. 15
.
Y
G
Fig. 14
W
Fig. 15
HOW TO REMOVE/INSERT THE CARD NAME HOLDER
• To avoid damage to the module front plate, mask the side that
will be in contact with the screwdriver blade;
• Insert the screwdriver (flat side) into the card-holder hole as
shown in
Fig. 16
;
• Move the screwdriver to the left as shown in
Fig. 17
to extract
the card name holder;
• Edit the card name then replace it inside the holder and refit:
insert the holder inside its housing from the left or right side
then push the other side until it clips into place.
Fig. 16 Fig. 17
Fig. 13
Door panel in BOOTLOADER mode
Art. 4533
Speaker unit with built-in camera
Art. 4533X
Speaker unit with built-in camera & proximity key reader