66251010-EN - V2.1 - 31/05/16
6
3600 Series
Art. 3676 - Installation instructions
B
E
C
D
C
A
G
F
Fig. 2
3600 Series
Videophone wall mounting instructions
135cm
Fig. 1
B
E
C
D
C
A
G
F
Fig. 3
C
M
L
H
I
M
Fig. 4
N
N
Fig. 5
1. Cables must be fed through the opening
E
(
Fig. 2
) of the mounting plate
C
, which should be fitted approximately 135cm from
finished floor level as shown in
Fig. 1
;
2. Place the mounting plate
C
against the wall feeding the wire group
D
through opening
E
of the mounting plate and mark the
fixing holes
A
(
Fig. 2
);
3. Drill the fixing holes
A
, insert the wall plugs
B
then with the cables threaded through opening
E
fix the mounting plate
C
to the
wall with the 4 screws provided
F
(
Fig. 2
);
4. Hook the PBC connection board
G
to the mounting plate
C
as shown in
Fig. 3
and connect the wires (using the screwdriver
provided) to the terminals as shown in the diagram provided;
5. Once the wires are connected, hook the videophone
H
to the mounting plate
C
as shown in
Fig. 3
;
6. Connect the Plug
I
on the ribbon cable from the videophone to the plug
L
on the PCB connection board
G
;
7. Place the videophone
H
against the 4 hooks
M
on the mounting plate
C
(in line with the 4 openings
N
on the rear side of the
videophone
Fig. 5
) and push down as suggested by the pointers in
Fig. 4
, the videophone will lock into place;
8. To remove the videophone, hold it firmly and push the unit in an upward direction until the videophone
H
unlocks from the
mounting plate
C
.
