EN - English - I
nstruc
tions manual
48
MNVCUPTMAXB_1511_EN
10.1.8.5 Preset Menu (Utility Preset)
It allows you to configure the following parameters:
1.
Scan Speed:
Speed used to reach the Preset
position after reception of a Scan control.
2.
Default Speed:
Preset default speed. This value
is used by function "Imponi Vel.?" (Force Speed)
to assign the same Preset speed.
3.
Default Dwell Time:
Preset default pause. This
value is used by function "Imponi Pausa?" (Force
Pause) to assign the same pause to each preset.
4.
Ramp Value:
Start and stop times. The higher
the number, the greater the acceleration/
deceleration during starting/stopping.
5.
Set Speed?:
To assign all Presets the same
default speed.
6.
Set Dwell Time?:
To assign all Presets the same
default dwell time.
PRESET UTILITIES
------------------------
1>SCAN SPEED : 20.00
2 DEFAULT SPEED : 10.00
3 DEFAULT DWELL : 3
4 RAMP VALUE : 12
5 SET SPEED?
6 SET DWELL TIME?
Fig.
104
10.1.8.6 Patrol Menu
1.
First Preset:
First preset of the Patrol sequence.
2.
Last Preset:
Last preset of the Patrol sequence.
3.
Random Mode:
Enables random execution. The
sequence is re-calculated on a continuous basis.
PATROL
------------------------
1>FIRST PRESET : 1
2 LAST PRESET : 250
3 RANDOM MODE : N
Fig.
105
10.1.8.7 Autopan Menu
1.
Preset Outward Movement:
Autopan initial
position.
2.
Preset Return Movement:
Autopan final
position.
AUTO-PAN
------------------------
1>PRESET OUTWARD: 1
2 PRESET RETURN : 2
Fig.
106
The Preset position approaching speed is
defined in the relative chapter (10.1.8.4
