Videotec NTX, Instruction Manual

Page: 21 / 184

Instruc
tion manual - English - EN
19 MNVCNVX_1915_EN
8.2.4 Connection of the Ethernet cable
The Ethernet cable shield on the operator
side must always be earthed. Use a shielded
RJ45 connector. Connect the sleeve to the
shielded RJ45 connector.
The product can be directly connected to an Ethernet
switch.
The example below shows a typical installation.
Switch
Personal
Computer
Fig. 30
9 Switching on
Make sure that the unit and other
components of the installation are closed
so that it is impossible to come into contact
with live parts.
Make sure that all parts are fastened down
firmly and safely.
The automatic pre-heating (De-Ice) process
could be started whenever the device is
switched on and the ambient temperature
is below -10°C (+14°F). The procedure is
necessary to guarantee correct operation of
the devices even at low temperatures. Pre-
heating procedure length: 60 minutes.
The unit is switched on by connecting the power
supply.
To switch off the unit disconnect the power.