Operation
80028008_030_B – 773625 – 2021-04-29
39
5.4
Connection to the sources
When a new video source is connected to the system, its dynamic
Preview (frame) is displayed in Source List, showing the name of
the socket/line used.
The Preview updates periodically as long as the signal remains
active.
To connect new video sources to the system, simply connect the
desired source to one of the compatible video connections
present on the connection plates installed on the pendant panels.
Depending on the configuration installed, the following
connections may be present:
–
DVI
–
3G/HD/SD-SDI
–
CVBS (Composite)
–
VGA
The technical drawing shows an example of the connection plates
installed on the pendant panels.
5.5
System shutdown
To shut down the system, proceed as follows:
In the event of system shutdown, it is possible to force system
deactivation by keeping the finger on the button until it is
completely switched off and then restart the device by following
the start-up procedure described in paragraph “System start-up”.
It is recommended to use forced shutdown only in case of an
emergency, as this procedure may cause data loss.
Step
Image
1.
Keep your finger on the touch
button for about 5 seconds,
until the flashing frequency of
the LEDs increases visibly.
2.
Once the frequency has
changed, remove your finger
from the button.
