IMV Indoor Motion Viewer - Install sheet Ed05EN
2
/
5
Indoor Motion Viewer IMV
I N ST AL L AT I O N D AT A S H E ET
Programming / RF testing / Mounting
The following provides summarized steps for device
programming, testing and mounting. For complete details,
refer to the control panel installation manual.
1
1
Loosen bottom screw
① (if present)
,
separate base from IMV
②
.
2
2
Install 2 SAFT LS14500 3.6V lithium batteries, observing
correct polarity.
Check that LED flashes before staying red.
3
3
Put control panel into programming/configuration mode.
4
4
Using a programmed alphanumeric keypad, proceed
through menus until the display shows ADD A NEW
DEVICE.
5
5
Press
Yes.
The display shows PRESS PROGRAM BUTTON
OF DEVICE.
6
6
Press and release program button on IMV using
your finger or a screw driver
①
.
The IMV LED flashes red
②
.
Wait for keypad display to show CAMERA (1 - 24)
PROGRAMMED.
7
7
Press
Yes.
The display shows RADIO RANGE TEST?
Press
Yes
again. The IMV LED starts flashing and keypad
display shows TEST IN PROGRESS.
8
8
Move the IMV to the intended mounting location and
make sure you receive a 5/5 or 9/9 indicating good
communication with the control panel.
9
9
Press
YES
to end radio range test, then press
Esc/No.
1
1
0
0
The display shows AREA ALLOCATION AREA: 1. Press
either arrow button repeatedly until desired AREA
number appears, then press
Yes
. By default all devices in
area 1 will be subject to the entry and exit delays.
1
1
1
1
The display shows NAME + LOCATION.
Enter appropriate device name (up to 16 characters). The
name of the device should describe its intended
mounting location or zone. Then press
Yes.
The display
will show the device number and name for your
verification.
1
1
2
2
Mount the IMV on the wall:
-
Follow the mounting rules on page 1
-
Hold the IMV base against the mounting surface and
mark the appropriate mounting holes.
-
Drill pilot holes and install anchors where needed.
-
Place base on mounting surface so that the pilot line
up and secure base with appropriate screws.
-
Attach camera to base and secure with screw if
required.
1
1
3
3
Press
Yes.
The display shows FUNCTIONAL DEVICE TEST?
Press
Yes
again and verify IMV operation. For example,
wave your hand in front of the sensor to activate the LED
which indicates detection.
1
1
4
4
Press
Yes
to end detection verification.
1
1
5
5
The display shows ADD A NEW DEVICE? Repeat steps 1 –
14 for remaining MotionViewers.
1
1
6
6
When finished, exit from configuration mode by pressing
and holding the ESC/NO for 5 seconds..
①
②
①
②
②
+
-
①
