Mounting procedure
>
Use proper tools and hardware.
>
To prevent false triggering the magnet must be aligned with the
upper part of the contact, following the markings. Use the plastic
adapters to align the magnet.
>
The magnet must always be mounted on the mobile part (door).
Note: do not install the contact and its magnet on a ferromagnetic
support
>
The distance between the magnet and the contact must be lower
than 1 cm.
>
Install that device indoors with a controllled temperature.
Note: if only the wired input is used, installing the magnet is not
needed.
1
Remove the base from the contact.
2
Hold the base against the wall and mark
the mounting points.
3
Drill.
4
Mount the base on the wall.
5
If using the wired input, connect
2 AWG22 wires from the wired
detector to the input terminals.
6
Mount the detector on its base
and lock with the screw.
7
Insert the magnet in its case.
8
Use the plastic parts to place the
magnet next to the detector.
9
Hold the magnet base against the wall and mark the mounting
points.
10
Drill.
11
Fix the mounting with the appropriate screw
s.
Mounting
brackets
Connect to the
wired detector
terminals
2
INSTALLATION SHEET
INDOOR CONTACT TRANSMITTER
ICT702
Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit
Français
• Retirez les piles avant toute opération de
maintenance !
• Attention ! Il y a un risque d'explosion si la batterie
utilisée est remplacée par un mauvais modèle !
• Respectez la polarité lors de la mise en place des
piles !
• Ne jetez pas les batteries usagées !
Ramenez-les à votre installateur ou à un point de
collecte spécialisé.
English
• Remove the batteries before any
maintenance !
• WARNING, there is a risk of explosion if a battery
is replaced by an improper model !
• Observe polarity when setting up the batteries!
• Do not litter the batteries when they are used!
Dispose of them properly according to Lithium
Metal requirements
Deutsch
• Batterien vor jeglichen Wartungsarbeiten
entfernen!
• Vorsicht, es besteht Explosionsgefahr, wenn eine
Batterie durch eine Batterie falschen Models
ersetzt wird!
• Achten Sie beim Einsetzen der Batterien auf die
Polung!
• Entsorgen Sie Batterien nicht im normalen
Haushaltsmüll! Bringen Sie Ihre verbrauchten
Batterien zu den öffentlichen Sammelstellen.
