Videofied BR651 Installation Sheet Download Page 6

EMEA SALES

23, avenue du Général Leclerc

92340 BOURG-LA-REINE

FRANCE

Hotline: +33 (0)820 846 620

Fax: +33 (0)1 82 69 80 10

© 2011 RSI VIDEO TECHNOLOGIES. VIDEOFIED

®

 is a Registered Trademark of RSI VIDEO TECHNOLOGIES.  

S

2

View

®

 is a registered trademark of RSI VIDEO TECHNOLOGIES.  Specifications subject to change without notice.

USA SALES

4455 White Bear Parkway, Suite 700

White Bear Lake, MN 55110

USA

Hotline: +1 877 206 5800

Fax: +1 651 762 4693 

www.videofied.com

FCC Regulatory Information for USA and CANADA

FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI VideoTechnologies may void the FCC 
authorization to operate this equipment.

FCC Part 15.105 Class B 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment 
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a particular 
installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•                      Reorient or relocate the receiving antenna.

•                       Increase the separation between the equipment and receiver.

•                       Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•                      Consult the dealer or an experienced radio/TV technician for help.

Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be 
installed and operated with minimum distance of 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.

Operation is subject to the following two conditions:

(1) 

This device may not cause harmful interference, and 

(2)                      This device must accept any interference received, including interference that may cause undesired operation.

P R O D U C T   S P E C I F I C A T I O N   S H E E T

Outdoor Proximity Reader Model 

BR651

Summary of Contents for BR651







Reviews: