Videocon FF250L, Service Manual

Page: 16 / 39

13
DISASSEMBLY
BOTTLE SUPPORT
• Bottle racks are given in glass shelf for holding the bottles kept on these
shelves.
• They may create problems in putting containers above a certain height
in daily use.
• To adjust them, first of all take the shelf out in which these bottle racks
are mounted.
• Take out the bottle rack from the groove in which it is located.
• Place it in the groove given above the previous groove as shown in
picture.
DISASSEMBLY
COMPRESSOR ADJUSTMENT
COMPRESSOR
ROLE
The compressor intakes low temperature and low pressure gas evaporated from
Evaporator of the Refrigerator, and condenses this gas to high temperature and high
pressure gas, and then plays delivering role to Condenser.
COMPOSITION
The Compressor is Composed of Compressor Apparatus compressing gas,
Compressor Motor moving Compressor Apparatus and Case protecting Compressor
Apparatus and Motor. There is Relay Assy (one set of PTC-Starter and Over Load
Protector (OLP)) in Compressor. On the other hand, because the Compressor consists
of 1/1000mm processing precision components and is sealed after production in
absence of dust or humidity, deal and repair with care.
NOTE FOR USAGE
• Be careful not to allow over-voltage and over-current.
• No Strike. If applying forcible power or strike (dropping or careless dealing), poor
operation and noise may occur.
• Use proper electric components appropriate to the Compressor.
• Note to Keep Compressor. If Compressor gets wet in the rain and rust in the pin of
Hermetic Terminal, the result may be poor operation and poor contact may cause.
• Be careful that dust, humidity, and flux welding don't inflow in the Compressor inside in
replacing the Compressor. Dust, humidity, and flux due to welding which inflows to
Cylinder may cause lockage and noise.