Videocon DDB DLX, Service Manual

Page: 14 / 74

14
D2h RESET PROCEDURE
If there is any abnormality in d2h working, then sometimes, it may
need to RESET the d2h Below are the options for d2h RESET.
A) Reset
– d2h Standby OFF - ON : -
1. The RESET key is situated in connectivity near ATV Tuner.
2. Insert a small toothpick or a small cylindrical stick in the RESET
hole of the Side control plate of the TV set to press the RESET
Button.
3. Press and release the RESET key for @ 1-2 Sec and release
the key.
4. Then d2h Signal will disappear and blank screen will appear with
“NO SIGNAL” OSD and d2h source will go to Stand By.
5. Then press and release the RESET key again, then the d2h will
start again on same channel.
B) RESET
– All d2h System Reset : -
1. Press and hold the RESET Key for 5SEC. {Do Not Press RESET
Key More than 5 Sec. or it will create other problem}.
2.
Then a message “Press OK to do Factory Reset” will appear on
the TV screen.
3. Then press the OK key of remote to proceed. This will Reset all
d2h settings and also erase all channel Tuning data and will
returned to Factory condition.
4. After Reset complete, the d2h will RE-Boot again and if d2h cable
is connected to TV, it will automatically scan and store all the d2h
channel data automatically.
C) RESET
– from DTV MENU: -
1. In DTV menu, go to SETUP menu.
2. Select the Factory Reset Option and press OK remote key.
3. Then the d2h will get reset.
Note: - This Reset will only applicable for d2h source only
and not for complete TV system.