4.5. Commencing a new charge cycle
A new charge cycle will commence when:
1. Bulk stage is complete and the current output increases to the maximum charge current for four seconds (due to a
simultaneously connected load)
2. If re-bulk current is configured; the current output exceeds the re-bulk current in float or storage stage for four seconds (due to
a simultaneously connected load)
3. The MODE button is pressed or used to select a new charge mode.
4. VictronConnect is used to select a new charge mode or change the function from ‘Power Supply’ to ‘Charger’ mode
5. VictronConnect is used to disable and re-enable the charger (via the switch in the settings menu).
6. The remote terminals are used to disable and re-enable the charger (from an external switch or BMS signal)
7. The AC supply has been disconnected and reconnected
Phoenix Smart IP43 Charger
Page 12
Operation
