Setup/ Basic Operation
Set Up
1 . Remove white protective needle cover by gently pulling towards front of unit.
2. Remove any packaging materials from the unit.
3. Connect the AC power cord to a wall outlet.
4. Turn the MAIN SWITCH ON (Push "I") at the back of the unit.
Note:
It is strongly recommended that this product should be operated only from the type of power source
indicated on the marking label.
To prevent interference, avoid bundling audio signal cables together with the AC power cord.
Basic Operation
1. Rotate the POWER/VOLUME knob clockwi se to turn the unit on. The LED display will illuminate.
2. Select the source by rotating the selection knob (FM/BTIAUX/PHONO).
3. Rotate the POWER/VOLUME knob to adjust to the desired sound level.
Listening through RCA LINE OUT
To listen through an external device through RCA Line Out, first reduce the volume level to minimum.
Insert the white and red plugs o f the RCA cable into the corresponding colors on the unit. Then insert
the opposite end into the external device.
Be sure to connect the white plug to the white jack and the red plug to the red jack.
CONDENSATION WARNING:
When the unit is moved from a cold or warm place, or is used following a sudden temperature change, there is the
danger that water vapor in the air may condense on the unit, preventing proper operation. In such
cases,
leave the
unit for 1-2 hours after plugging it Into an
AC
outlet to allow it to stabilize at the temperature of its suffoundings.
FM Radio Operation
1. Rotate function knob to select "FM" function.
2 Tune to the desired station by using the Radio Tuner Knob.
