Victoria VITTORIA 8, Instruction Manual

Page: 7 / 24

03.2021 INSTRUCTION MANUAL for installation and operation of pellet stove VITTORIA 8
7
Picture.2.
The ash from the combustion process is conducted in an ashtray(O)underneath the combustion chamber. The ashtray must be
periodically cleaned by pouring in a metal container or by a vacuum cleaner, but only when the pellet stove is cold.
By the internal mounted air fan (E), the hot air is pushed in the room and multiplies the efficiency of the pellet stove. The room
temperature is measured by temperature sensor installed in the stove.
High efficiency and low emission of the pellet stove is guaranteed by an electronic control system that manages the amount of
fuel, the flue gases conduction, supplying of combustion air and operation of the air fan. The control panel of the control system
is placed behind the upper panel of the pellet stove(M) fromPicture2. Through the control panel, the user can visualize and
manage all stages of the operation of the pellet stove.
8.Fuel.
Pellet stove e designed and programmed to burn wood pellets. They have a cylindrical shape, and they are made of compressed
by a high-pressure timber, without adhesive and additive materials. The wood pellets are sold in packages weighing 15 kg, which
facilitates their storage. For better combustion, the wood pellets must be stored in dry and ventilated area. Pellet stove is
designed, developed, programmed, and tested to operate with wood pellets class A1, according to EN plus and BDS EN ISO
17225-2: 2014 with the following parameters:
Maximum diameter: Ø 6 mm
Maximum length: 25 mm
Maximum moisture content: 8 %
Maximum ash content: 0.5%
Minimum calorific value: 4300 ccal/kg
Good quality wood pellets ensure good combustion and lower emissions into the atmosphere.
The use of wood pellets with a lower quality results in a need for more frequent cleaning of the combustion chamber, reducing
heat output and efficiency. They are increasing the fuel consumption sensitively. Inadequate wood pellets can cause blockage of
the auger and to stop the operation of the pellet stove.
IF PELLET STOVE IS BLOCKED, THE REASON WILL APPEAR ON THE DISPLAY AND IT WILL BE SAVED.
Using wood pellets of poor quality or non-manufacturer recommended as above may compromise the operation of
the pellet stove and lead to termination of the warranty.
Pellet stove should not be used to burn other types of fuels or materials. Invalid guarantee!
9.Appliance installation.
Trained and competent technicians or companies must perform the installing a pellet stove! Qualified technicians
should perform all activities in inspection and repair of electrical components. Switch off the pellet stove from the
electric supply before any inspection or repair!
Refer to the regulations valid for the country, where the pellet stove will be used, if you do not find the information you are
interested in this instruction manual.