- 8 -
Figure 3-1 replacing batteries
Section Four Power on/Power off the Meter
（
1
）
Turn on/off the meter
Press
〔
power
〕
key to
electrify the meter, and
repress
〔
power
〕
key for more than 1 second to cut off the
power.
When turning on the power, the meter starts to make
inner diagnose and display in full screen, and then
undertakes corresponding operation.
Note
To ensure correct electrifying operation, please wait
for 5 seconds to turn on the meter again after cutting off
the power.
（
2
）
Automatically turn off the power
The default factory value is set as: the meter will
automatically turn off if no operation has been made
within 15 miniutes.
The Users can set by themselves to choose whether
using this function or not (See the detailed section).
Section Five Output of the Meter
The meter generates DC current or thermocouple
simulate temperature by the Users from the
corresponding output terminals
（
OUTPUT
）
.
Caution
Do not apply any voltage to output terminal;
otherwise damage to interior circuit may occur if the
voltage is not proper.
（
1
）
DC voltage output
1. Insert the testing probe into the jack of the meter’s
output terminal (OUTPUT), and connect the other
end with input terminal of the Users’ meter, see
Figure 5-1:
2. Press
〔
FUN
〕
key , select V/mV function, and display
‘V’ or ‘mV’ unit;
3.
Press
〔
RANG
〕
key, select 100.00mV or 1.0000V
range;
4. Press
〔
τ
〕
/
〔
υ
〕
key, select output set bit;
