There is a LED on the charger. The light is
red
when the battery is charging and changes to
green
when
the battery is fully charged. The charger then stops charging, so there is no need to immediately unplug
the charger.
Note:
When the 4 LEDs on the battery are lit, this does not necessarily mean that the battery is fully
charged. You can only be sure the battery is fully charged once the light on the charger is
green..
It is advisable to run the battery down to the 5 to 10% charge level and then fully recharge it the
first 3 times.
About the battery
> The 4 LEDs indicate the approximate battery status. Each LED represents about 25% of the full
battery charge.
- If only one LED is on, it is recommended that you charge the battery.
- The 5-block display on the handlebar shows the status with more precision.
> Do not place the battery in direct sunlight.
> Charge the battery every 2 months when not in use.
> The battery can be charged at any time. It does not harm the battery to charge it when it is at, say,
50% or 75%. We do recommend, however, that the battery be discharged almost completely and
then fully recharged every now and then.
> Do not drain the battery completely.
> In very cold temperatures the battery will operate less efficiently than at temperatures of around
10-20 °C (50-68 °F), and this may reduce the action radius by as much as 30%. This also applies to
charging: the charging process will take longer.
Operating computer and reading display
There are 2 displays available for the Victesse models with front-wheel motor: a display with integrated
control on the left side of the handlebar, and a centrally located display on the handlebar with control
on the left side of the handlebar.
Display on the left side of the handlebar
Once the battery is turned on, the computer can be turned on with the
Mode
M
button
on the control
panel by holding it for 2-3 seconds.
Turning on
1. Lock the battery and turn on the electrical system by turning the key all the way to the right (
“on”
).
2. Turn on the display by pressing the
Mode
M
button
for 3 seconds.
3. Use the speed adjuster to select the desired amount of pedal assistance by pressing the
MINUS
-
and
PLUS
+
buttons
.
4. As soon as you pedal, the assist will turn on.
5. You interrupt the assist by stopping pedaling or squeezing the brakes.
Victesse
English-
4
