1
HAZARD IDENTIFICATION
Definitions for identifying the various hazard levels are provided below.
This safety alert symbol indicates important safety messages. When you see this symbol, be alert to the possibil-
ity of personal injury. Carefully read and fully understand the message that follows.
The use of the word “DANGER” identifies an immediate hazard with a likelihood of
death or serious personal injury if instructions, including recommended precautions,
are not followed.
The use of the word “WARNING” identifies the presence of hazards or unsafe practices
that could result in death or serious personal injury if instructions, including
recommended precautions, are not followed.
CONTENTS OF KIT
Item No.
Description
Qty.
1
Power Drive/Tool Stand
1
2
Foot Switch for Power Drive
1
3
Adapter Plate
1
4
Pins
2
5
Bolts with Flat Washers and Wing Nuts
4
6
Power Drive Trigger Lock
1
7
Power Drive Adapter
1
IMPORTANT INFORMATION
These instructions are a supplement to highlight the necessary steps that must be performed to adapt a VE226 Roll
Grooving Tool for use with a Ridgid 700 Power Drive. Refer to the VE226 Operating Instructions (supplied with this kit) and
the Ridgid 700 Operator’s Manual for complete safety information, tool setup, grooving, troubleshooting, maintenance
information, etc.
1. Select location for tool. The choice of tool location and position should take into account the following factors:
a.) Pipe handling support requirements
b.) Power supply requirements
c.) Pipe support and tool anchoring requirements
2. Place the power drive/tool stand on level ground. Secure the stand to a platform or the floor.
1
2
3
4
5
6
7
® Registered Trademark of Victaulic
© Copyright 2001 Victaulic
Printed in U.S.A
