Not for
Reproduction
33
NOTE
If you have to replace one or both rear wheels or tyres,
make sure that any differences in their external diameter does not exceed
8-10 mm. Change in wheel/tyre size may cause an uneven cut & may be
necessary to adjust the alignment of the cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1)
& supporting washer (2) back in place.
6.3.3 Replacing & repairing the tyres
The tyres are «Tubeless» and so all
punctures must be repaired by a tyre
repairer following the procedures required
for this kind of tyre. If you have to replace a tyre, make sure that any differences in
their external diameter does not exceed 8-10mm
1
2
6.3.4 Replacing the bulbs
(if present)
The bulbs (18W) have a bayonet
fitting and are installed in the
bulb holder which can be taken
out by turning it anti-clockwise
with pliers.
• Type “II” bulbs (LED)
Unscrew the ring-nut (1) and remove the connector (2).
Remove the LED illuminator (3), secured by screws (4).
6. MAINTENANCE (cont.)