ZigBee Pro Module
Installation Guide
3
Viconics Technologies Inc.
|
9245 Langelier Blvd.
|
St.-Leonard
|
Quebec
|
Canada
|
H1P 3K9
|
Tel: (514) 321-5660
|
Fax: (514) 321-4150
028-0425-01
www.viconics.com
May 2015
©
2
01
5 V
ic
onic
s T
ec
hno
lo
gi
es
. A
ll r
ig
ht
s r
ese
rv
ed
.
Quick Setup
The quick set-up shows how to pair a ZigBee sensor with a Room Controller. It assumes that all the back-end
configuration of the stand alone Room Controller acting as coordinator or the Multi-Purpose Manager (MPM)
coordinator for the ZigBee network is complete. It assumes the User is familiar with the Permit Join function and the
Wireless Ecosystem screen functions.
PROCEDURE
1. Set Permit Join on Room Controller (or networked MPM coordinator if used) to On.
2. Go to first unused Zone screen in Wireless Ecosystem section of Room Controller’s interface.
3. Insert battery or remove pull tab (for contact sensors) to activate ZigBee sensor.
4. Verify sensor has joined network and Paired field status reads Yes on Zone screen.
5. Set the Set function to parameter.
6. Set Permit Join on Room Controller (or networked MPM coordinator if used) to Off.
7. Do step 7 for door or window contact sensors. Otherwise go to step 8.
a.
Go to first screen in Configuration section of interface.
b.
For window sensor, set UI 16 to Window.
c.
For door sensor, set UI 17 to Door Dry.
8.
Physically install sensor.
TROUBLESHOOTING
If the short procedure described here is insufficient or an MPM or Room Controller needs to be configured, refer to the
VT8000 Room Controllers ZigBee Pro Wireless Integration Guide available at
www.viconics.com.
