ZigBee Module Installation Guide
3
©
2
01
4 V
ic
onc
is
T
ec
hno
lo
gi
es
. A
ll r
ig
ht
s r
ese
rv
ed
.
Viconics Technologies Inc.
|
9245 Langelier Blvd.
|
St.-Leonard
|
Quebec
|
Canada
|
H1P 3K9
|
Tel: (514) 321-5660
|
Fax: (514) 321-4150
028-0425-01
www.viconics.com
|
November 2014
Quick setup
This short procedure is intended to let you pair a ZigBee sensor with your Room Controller. It assumes that all the back-end configuration
of the stand alone Room Controller acting as coordinator or the Multi-Purpose Manager (MPM) coordinator for the ZigBee network has
already been done, and it assumes that the user is familiar with the
Permit Join
function and the
Wireless Ecosystem
screen functions.
PROCEDURE
1. Set
Permit Join
on your Room Controller (or networked MPM coordinator if used) to
On
.
2. Go to the first unused
Zone
screen in the
Wireless Ecosystem
section of the Room Controller’s interface.
3. Insert the battery or remove the pull tab (for contact sensors) to activate the ZigBee sensor
4. Verify that the sensor has joined the network, and that on the
Zone
screen the
Paired
field status reads
Yes
.
5. Set the
Set function to
parameter to the correct setting.
6. Set
Permit Join
on your Room Controller (or networked MPM coordinator if used) to
Off
.
7. Conditional to use of door or window contact sensors
a) Go to the first screen in the
Configuration
section of the interface.
b) For window sensor, set
UI 16
to
Window
c) For door sensor, set
UI 17
to
Door Dry
8. Physically install the sensor.
TROUBLESHOOTING
If the short procedure described here is insufficient or an MPM or Room Controller needs to be configured, please refer to the VT8000
Room Controllers ZigBee Pro Wireless Integration Guide available on
buildingsdownloads.schneider-electric.com
.