VRP5000W1000W
24 VAC Powered Zigbee Repeater
For Viconics Wireless Networks Applications
(Issue Date May 3
rd
, 2012
– 028-0265_R4)
Product overview
The VRP5000W1000W wireless repeater has been specifically designed to be
used within a Viconics wireless ZigBee network for Viconics wireless controllers.
The repeater is intended to be a low cost additional communication component
used when some remote controllers are too far from the main mesh of Viconics
device cluster and cannot communicate with either:
A VWG ( Viconics Wireless Gateway )
OR
A JACE wireless communication card and related WirelessStatNetwork driver file that have been
specifically designed to be used by the Niagara AX® powered JACE controllers.
The repeater(s) will enable the remote controller(s) to re-establish communication and act as bridge(s) to the
main mesh.
The repeater(s) can be installed where most convenient such as a wall or in a suspended ceiling space if
required.
The following documentation is available on
VWG hardware installation is available in document LIT-VWG-40-INSTALL-Exx
VWG BACnet integration information is available in document ITG-VWG-40-BAC-Exx
VWG information on design considerations of a wireless mesh network set-up and diagnostics is
available in document LIT-VWG-40-SETUP-Exx
Jace2 communication card set-up, integration information and design consideration of wireless mesh
networks for set-up and diagnostics is available in document MAN-Wireless-Stat-Driver-Guide-Exx
0028-0265_R4_LIT-VRP5000W-E04.doc
www.viconics.com / [email protected]
Viconics Controller(s)
Main Mesh Cluster
VRP5000W1000W
Repeater
Remote Viconics
Controller(s) Cluster
