2.2
Connection
•
Micro SD memory slot on the bottom board
Remove the cap at bottom of the camera to insert the SD memory card.
•
Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a cross-over cable is used
for direct connection to PC, while a direct cable is used for connection to a hub. You can also use a router featuring
PoE (Power over Ethernet) to supply power to the camera.
•
Connecting Alarms
AI (Alarm In):
You can use external devices to signal the network camera to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G (Ground):
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
AO (Alarm Out):
The network camera can activate external devices such as buzzers or lights. Connect the
device to the AO (Alarm Out) and G (Ground) connectors.
•
Connecting the Power
Connect the power of 12VDC for the network camera. Connect the positive (+) pole to the ‘+’ position and the
negative (-) pole to the ‘-’ position for the DC power.
–
Be careful not to reverse the polarity when connecting the power cable.
–
A router featuring PoE (Power over Ethernet) can also be used to supply power to the camera.
–
For the power specifications, refer to the appendix, product specification
in the User manual
.
–
If PoE and 12 VDC are both applied, the camera will be supplied with power from PoE.
•
Connecting Audio
Connect speaker to audio line output and external Mic to audio input line.
8
