Vicon V661D-312N-1, Installation And Operation Manual

Page: 7 / 28

- In Ceiling
1. Loosen the three Torx screws as shown in Figure 1.
Do not remove the screws. Lift the trim ring off the mount and set aside.
2. Remove the ceiling tile from the ceiling. Draw a circle with a diameter of 116mm on the tile.
(You can use carton with a hole). Cut the circle out of the ceiling tile. (Figure 2)
3. Install the bottom case in the ceiling as shown in Figure 2.
Turn the locking flaps outward as shown in Figure 3 and 4 to attach the bottom case to the ceiling.
4. Install the trim ring onto the surface mount and tighten the Torx screws.
Note: Set the surface mount aside. It is not needed for this installation.
Note:
The ceiling tile cannot be thinner than 0.15 Inch (3.7mm)
7
2
(Flush Type
Hole:Φ116mm)
A