Figure 3
Front View with End Cap Removed
2. Follow the instructions above for
attaching the front end of the strut to the
wall mount, which should be already secured to
a
Corner Mounting Bracket.
3. Attach the rear end of the strut to the
face of the corner strut bracket using a
nut and bolt.
4. Tighten the attached hardware and replace
the end cap and the three screws.
ADJUSTABLE HEAD
For the
The
Adjustable Head consists of three
parts: a circular base, a platform, and
a
clamping piece, plus related hardware.
The
may be packed in either one of
two ways. In one, a
reusable hex
bolt is used to retain the base, platform, and
clamp in proper relation to each other. The
stamped hex nut, however, is not to be used in
mounting the unit and should be discarded. In
the other type of packaging, a
hex
bolt and washer are packed in a separate bag,
LEGEND
1. Hex nut (4)
2 . Lockwasher (4)
3 . spacer (4)
4. Stud plate bolt (4)
5. Adapter bracket cover (1)
6. Nut insert (3)
7. Adapter bracket (1)
8 . Groove (1)
1. To install the
remove the bolt and
washer from the adjustable head (if this
packing method has been used), or from the
separate bag. Slide the washer onto the bolt
up to the head, and insert the bolt through
the clamp and base. The washer prevents the
bolt head from recessing into the clamp. The
threaded portion of the bolt will protrude
about
from the bottom of the circular
base.
2. Align the adjustable head in the desired
direction.
3. Thread the bolt into the threaded hole in
the mount. Tighten the bolt finger tight,
followed by an additional half turn. See
Figure 4.
CAUTION: Further tightening could damage the
D o
MAINTENANCE
The
and
Wall Mounts and
Associated Equipment do not require
maintenance.
4
X417-988