Vicon V1599, Installation & Operation Manual, Page: 74 / 80

Pilot Ultra XX189-00-XX Reference
•
63
--------------------------------------------------------------------------
To change any of this, press any key within 5 seconds
(M)odify any of this or (C)ontinue? [M]
For each of the following questions, you can press <Return> to select the
value shown in braces, or you can enter a new value.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface? [Y]
IP address(0.0.0.0 = RARP, 255.255.255.255 = DHCP/BOOTP)? [192.168.0.10] 129.69.200.41
Subnet mask for LAN (0 for none)? [255.255.255.0]
Should there be a default gateway for packet routing? [N] y
What is its IP address? [0.0.0.0] 129.69.200.10
HARDWARE PARAMETERS:
Baud rate for serial channels [38400]
V1599 CDU NETWORK BOOT ROM PARAMETERS:
Do you want to create a host list?[N] N
How long (in seconds) should CPU delay before starting up? [5]
---------------------------------------------------------
10. You will be presented with your choices and given a chance to edit any of the settings again. It may take
time to update the information before you see the “Done” message on your PC screen.
11. Repeat this procedure for Ethernet Card 2 if applicable to your system.
The current IP address,
which uses the Vicon
default prefixes of 192.168,
is shown in brackets. The
user has entered a new IP
address of 129.69.200.41.
This setting enables the
default gateway. The
next setting defines the
IP address of the
Creation of a host list is presently
unsupported. Answer "N" to this
question.