Vicon V1411X-DVC, Installation & Operation Manual

Page: 9 / 16

4
•
Keypad Setup XX074 Rev 101 Variable-Speed Keypad
Keypad Setup
Note: (For NOVA mode only) Before powering your control system, perform the keypad setup described in this
chapter. Make sure to define the keypad baud rate (all keypads in your CCTV system must have the
same baud rate) and keypad address (each keypad must have a unique address). After you have set
up the keypad completely, power your control system and refer to its documentation to set the Keypad
State to
Auto
in the control system programming menus.
To enter Keypad Setup mode, perform the following keystrokes:
Then use the following methods to navigate through and chose a parameter:
To exit Keypad Setup mode, perform the following keystrokes:
Setup Parameter Description Choices
Display Contrast Sets the LCD contrast. (view the LCD window)
Address Sets the address for this keypad.
•
-- (use this setting
for Standalone
mode).
•
1-64 (for NOVA mode).
Baud Rate Sets the communication baud rate. All keypads in
your NOVA system must have the same baud rate!
•
1200, 2400, 4800, 9600,
19200
Joystick Profile Determines the relative pan-and-tilt speed based
on how far the joystick is deflected from its center
position. As the joystick is deflected further from
center, the pan-and-tilt speed increases.
•
RELATIVE PAN AND TILT SPEED
JOYSTICK DEFLECTION
1-Linear
2-Square Law
3-Cube law
4
Press & Hold Press
PROG
Release
PROG
Setting Autopan Speed
Press & Hold
Note: This procedure does not change the manua
A/P
Deflect more/less
for faster/slower
speed.
de
Press
f
SPEED
auto anning.
Toggle key to
automatically
adjust to ambient
lighting conditions
or deactivate. Note that au
priority over
avoid excess
mechanism,
when you ar
Auto Iris
A/I
1
Press & Hold Press
PROG
Release
PROG
Tilt up/down to display
choices.
A/P to save your choice
and move to the next
parameter.
A/I to move to the next
parameter without saving.