XX074-02-01 Rev 703 Variable-Speed Keypad
Passcode Setup
•
5
Passcode Setup
You may use passcodes to limit use of the keypad. Eleven passcodes are permitted, one for a manager and
ten users. The manager has access to all functions and setup parameters, including passcode setup. Only
the manager may setup the keypad using mode 4, which is discussed in the next chapter.
Note: From the factory, passcodes are disabled and the keypad can be immediately accessed. The manager
passcode must be set up in order to have user passcodes. The manager passcode is always passcode
1. Passcodes are defined to be 4 digits from the factory, but the manager can change this as
discussed in the Keypad Setup chapter. Do not begin a passcode with “0”.
To set up passcodes:
1. To enter Passcode Mode, perform the following keystrokes:
2. The LCD will display:
Edit Passcode 1
New Passcode ----
3. Passcode 1 is always the manager passcode. Enter the manager passcode and press
A/P
. If the
keypad sounder is enabled, as discussed in the next chapter, the keypad will beep twice when a new
passcode is entered.
4. The LCD will display:
Edit Passcode 2
New Passcode ----
5. Passcodes 2 – 11 are for users. Enter the 4-digit passcode for the first user, press
A/P
to save the
passcode and continue to set up passcodes if needed. Note that you do not have to use contiguous user
numbers; for example, you can skip passcode number 3 and continue setting up with passcode 4. To skip
a passcode during setup, or scroll through passcodes, use the A/I key.
6. To exit the Passcode Setup mode, perform the following
keystrokes:
To edit passcodes
, a manager must enter the passcode system and perform the steps above to change or
view the passcodes. Note that a user may edit his own passcode.
To delete all passcodes
, enter a master
passcode of all zeroes.
To delete a user passcode only
, enter all zeroes for that user passcode.
To recover a
lost manager passcode
(and retain the programmed user passcodes), contact Vicon Technical Support at 1-
800-645-9116 (U.S.) or +44 (0) 1489 566330 (U.K.).
To log on to the keypad:
If passcodes have been entered into the system as defined above, you must enter a valid passcode to use
the keypad. After the initial startup screen, the keypad will display:
Vicon V1411X-DVC
Passcode?
----
Enter a 4-digit passcode as defined above. Mode 4, Keypad Setup, may only be accessed by the manager.
5
Press & Hold
Press
PROG
Release
PROG
1
Press & Hold
Press
PROG
Release
PROG
