Vicon V1000AH, Installation & Operation Manual

Page: 10 / 15

4
••
Installation X515 Rev 1298 Adjustable Mounting Heads
5. To adjust the camera/housing position, loosen the hex-head mounting bolt sufficiently to allow the
camera/housing to be rotated and angled up or down to cover the exact scene to be observed. Retighten the
mounting bolt.
Figure 1
V1000AH Installation
Installing the V1600AH
The V1600AH consists of three parts, the circular base, the mounting platform, and the clamp, plus related
mounting hardware, including a 1/4-20 x 2-1/2 inch stainless steel hex-head bolt, a flat washer, and a 1/4-20
stainless steel hex nut. Additional washers may be present for packing purposes; these are not used in
installing the adjustable head. Note the relationship of the base, clamp, and platform before removing the hex
bolt for installation. Some units are packed with a corrugated cardboard piece which holds the parts in proper
relationship during shipping. Remove this cardboard and discard it.
The V1600AH is intended for use with the V1600WM Wall Mount or the V14LCM Column Mount. Installation is
different on each of these units. Follow the instructions for the appropriate mount described below.
Installation on the V1600WM
The 1/4-20 hex bolt, the 1/4-inch washer, and the 1/4-20 nut are required to install the V1600AH on the
V1600WM. Refer to Figure 2.
1. Place the round edge of the V1600AH base onto the mounting platform of the V1600WM.
2. Insert the clamp diagonally (with flat side facing up) inside the V1600AH mounting plate. Position the clamp
horizontally and lower it until it rests on the rounded edges of the mounting plate.