Vicon RV 4116, Operation And Maintenance Manual

Page: 119 / 192

2
1
7
-2
0
8
-1
.f
m
ID
M
English
- 113 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Net binder unit (electronic)
Part 6
HOW TO ADJUST THE CUT RESET DEVICE
98
Follow the instructions.
min 3 mm
1
2
ID
M
-2
1
7
2
0
8
0
0
9
0
1
.p
d
f
D
E
F
B
A
C
1. Stop the tractor without turning
off the motor, engage the parking
brake, and then disconnect the
power take-off.
2. Place lever (D) of the hydraulic
control valve in the tractor in po-
sition
1 to open the tail gate.
3. Switch off the engine of the trac-
tor, and then disengage the igni-
tion key.
4. Open the cover (A) .
The hooks (B) are completely lift-
ed.
5. Use the nuts (C) until the arm (E)
and the lever (F) are at 3 mm
(see figure).
6. Definitively tighten nuts (C) .
7. Close the cover (A) .
8. Start the engine of the tractor
from the driver’s seat.
9. Place the lever (D) of the hydrau-
lic control valve in the tractor in
position
2 to close the tail gate.
HOW TO DEACTIVATE AND ACTIVATE THE CUTTING DEVICE
99
Follow the instructions.
ID
M
-2
1
7
2
0
8
0
0
6
0
1
.p
d
f
C
B
A
1. Make sure tractor PTO is disen-
gaged.
2. Stop the engine, apply the park-
ing brake and disengage the ig-
nition key.
3. Open the cover (A) .