V2360W Panoramic Fisheye Series | Quick Guide
10 -
5. Attach the rear side of camera to the fixed flat bracket and align the 3 screws with the corresponding holes
on the bracket as shown in figure below. Rotate the camera clockwise until it clicks into place so that
camera will be firmly mounted onto the bracket. To disassemble, rotate the camera counterclockwise and
remove it from bracket.
Figure 2 - 1: Mounting The Camera
Note
The correct size holes for TP4 screws with plastic anchors are of diamet
er φ 6.35 mm (0.25 in,).
Seal up waterproof rubber hole with plug when no cable is in use.
Rubber Plug
Waterproof
Grommet
1
4
3
2
Note
:
Feed the unterminated CAT5 cable through the hole in the solid
grommet and terminate the cable with the appropriate connector.
To maintain watertight integrity/warranty, be sure to use the
appropriate grommet
.
Jacketed cables with a diameter between
0.165-0.2 in. (4.2mm- 5mm) must be used.
Fully tighten screws after installing cables and uSD to ensure IP66
seal.
Summary of Contents for Roughneck Pro V2360W-12
Page 21: ......
