88
Maintenance
General
conditions
This information relates to general servicing work. For all servicing
work, the implement must be locked in operating position. If transport
position is required for maintenance work, you will find appropriate in-
formation for the maintenance work.
Direction
specifications
The direction specifications (right, left, front, rear) are meant in relation
to the direction of travel.
Rotary direction is defined as follows:
Maintenance terms
Listed in this table are short explanations of the most important
maintenance terms.
Description
Rotary direction right
clockwise
Rotary direction left
counter-clockwise
Rotation about the ver-
tical axis
viewed from top to bottom
Rotation about the hori-
zontal axis
at right-angles to the direction of travel viewed from left to right
Rotation of screws, nuts and
suchlike
always viewed from the actuation face
Task
Explanation
Greasing
Apply grease to the slide surfaces using a brush.
Lubricating
One or two presses of the grease gun, if not stated otherwise
Oiling
If not specified otherwise, use only plant-based oils, such as rapeseed oils.
Used oil will endanger your health and in addition its use is strictly prohibited
Replacement
Replace the appropriate part in accordance with the directive in the section
Maintenance
Inspection
Check as required the tyre pressure, adjusting dimensions and seal tight-
ness, and replace any worn parts or seals
Observe the maintenance inter-
vals
The specifications relate to an average usage of the implement. If subjected
to heavier duty (e.g. by contracting companies), select the maintenance in-
tervals to be shorter. Also for extreme working conditions (for example heavy
dust production) shorter maintenance intervals are possible
Summary of Contents for RF 2235
Page 5: ...Inhaltsverzeichnis 5...
