Internet/Intranet (WAN) Requirements
ViconNet can be used over any type of network configuration using TCP/IP protocol including Intranets,
WANs and the Internet itself. When used on any network other than the Internet, a minimal amount of security
precautions need to be taken. However, the Internet is an environment rich in security violations in the form of
viruses and hackers.
Therefore, Vicon strongly suggests the use of a hardware firewall and router. This is the best protection
against Internet security violations. In addition, it is suggested to use Microsoft’s XP Embedded Personal
Firewall software. This software module is available in certain versions of the Windows XP Embedded
operating system. To find the XP Embedded version, exit the ViconNet application by using the Exit-to-OS
button from the Site Configuration window. At the desktop, the version will be displayed in the lower right
corner.
1.
All XP Embedded versions lower than or equal to D2, E2, F2, G1 and J will have the Personal
Firewall module. However, they will require configuration. Refer to Tech Note TN019 for information
on setup.
2.
All Embedded versions higher than D2, E2, F2, G1 and J will have the Personal Firewall module
included and configured. However, these versions will not include setup of the feature ICMP, which
will allow an incoming echo request (ping) command. Refer to Tech Note 1400-0001-62 for
information on setup.
3.
In XP Embedded versions K and higher, the Personal Firewall module will be installed and
configured. In addition, this version will provide the feature ICMP, which will allow an incoming echo
request (ping).
The Personal Firewall will block all Windows known open ports.
18
•
Network Requirements
XX112-70-00 Rev 904 Kollector Pre-Installation Requirements
