Coupling the machine
36
Coupling the PTO
shaft
When coupling the PTO shaft, make sure it is in the correct position.
Check whether the PTO shaft must be shortened before coupling.
Shorten the PTO shaft if necessary.
→
»PTO shaft length«, page 28
Check that the tractor's PTO stub shaft is clean and lubricated.
Couple the PTO shaft to the tractor and the machine.
Ensure that the PTO shaft is engaged on the shaft ends.
Secure the guard tubes so that they cannot rotate.
Couple the single joint with slip clutch to the machine's PTO stub
shaft.
Wheel chocks
Remove the wheel chocks from in front of the wheels.
Place them in the holder next to the left-hand warning sign and lock
into place.
Tractor
Single joint with
overrunning clutch
50 mm
Pin
PTO shaft
Ensure the minimum spacing
In the work position, the space between the PTO shaft and the pin
must never be less than 50 mm. Otherwise the PTO shaft may be
damaged, for example when driving over an undulation in the
ground. Damaged PTO shafts can cause injury to persons or
damage the machine.
Wheel chocks
Summary of Contents for Andex 714 T Vario
Page 4: ...Table of contents 4 ...
