Delivery and assembly
28
PTO shaft length
The length of the PTO shaft was selected at the factory to suit almost
all types of tractor. Only in exceptional cases is a correction of the PTO
shaft length required on individual tractors. Check the length of the
PTO shaft on each tractor prior to first use.
A manufacturer's operating manual for the PTO shaft is enclosed. This
includes detailed information on the relevant version of the PTO shaft
and must be observed.
Safety
Switch off the tractor and secure it
Before you dismount:
Switch off the tractor.
Remove the ignition key.
Secure the tractor against rolling away.
An unsecured tractor can run you over or trap you. Serious
or fatal injury may be caused as a result.
Check the angle of lock
The PTO shaft has a wide hinge joint giving the tractor a steering
angle of up to 80°. Make sure that the PTO shaft is not damaged
during sharp cornering. The machine may be damaged as a
result.
Correct length
A PTO shaft that is too long must not be used. This would result in
damage to the drive bearings of the tractor and the machine.
Coupling to the pending attachment
Check and adjust the length of the PTO shaft when using the
pending attachment hitching system. A PTO shaft that is too long
may cause damage to the machine.
Summary of Contents for Andex 714 T Vario
Page 4: ...Table of contents 4 ...
