VUL570
Series
Use and Care Manual
This humidifier adds water vapor to the surrounding air helping the user to breathe better. If you have
any questions about the operation of your Vicks
®
EasyFill Cool Mist Humidifier, call our toll-free Consumer
Relations line at 1-800-VAPOR-1-2 (1-800-827-6712) or e-mail us at [email protected].
Adjustable mist control
No filters to replace
Easy to clean
Easy
Fill
Cool Mist Humidifier
IMPORTANT!
READ AND SAVE THESE INSTRUCTIONS
2
3
1.
The humidifier should always be placed
on a firm, flat, waterproof surface at least
four feet (1.2m) away from bedside, 12
inches (30 cm) from the wall and out of
reach of patients, children and pets. Be
sure the humidifier is in a stable position
and the power cord is away from heated
surfaces and out of the way to prevent the
humidifier from being tipped over.
2.
The humidifier should not be left
unattended in a closed room since
air
could become saturated and leave
condensation in front of unit, on walls
and furniture.
Leave room door partly
open.
Do not
aim Mist Outlet directly at
children, walls or furniture.
3.
Before using the humidifier, extend the
cord and inspect for any signs of damage.
Do not
use the unit if the cord has been
damaged.
Do not
operate with power cord
coiled or with twist tie in place.
4.
The humidifier has a polarized plug (one
blade is wider than the other) as a safety
feature. This plug will fit into a polarized
outlet only one way. If the plug does not
fit fully into the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician.
Do not
attempt to defeat this
safety feature.
5.
CAUTION:
To avoid fire or shock
hazard, plug the humidifier directly into
a 120V AC electrical outlet. To avoid risk
of fire, shock or personal injury,
do not
use an extension cord or power strip.
6.
The humidifier should always be unplugged
and emptied when not in operation or
while being cleaned. Shut off and unplug
humidifier before moving.
Do not
move or
tilt humidifier while it is in operation. Plug
and unplug unit with dry hands.
Never
pull
by cord.
7.
Do not
operate the humidifier without
water. Turn off and unplug unit when tank
is empty.
8.
Humidifier requires regular cleaning. Refer
to and follow cleaning instructions.
9.
Do not
operate outdoors; this humidifier is
intended for indoor residential use only.
10.
Do not
cover or insert objects into any
openings on the unit.
11.
Do not
block intake or output vents.
12.
Do not
attempt to repair or adjust any
electrical or mechanical functions on this
humidifier. Doing so will void your warranty.
13.
Do not
place in direct sunlight, high
temperature areas or near computers or
sensitive electronic equipment.
14.
Do not
touch the nebulizer while the unit is
plugged in as burns could result.
15.
Do not
touch skin with exposed VapoPad
®
or place VapoPad
®
on furniture, fabric,
bedding or plastic.
16.
Do not
add any medications (e.g. Kaz
Inhalant or Vicks VapoSteam
®
or oils)
into Mist Outlet, Base, Water Reservoir
or Water Tank.
SAVE THESE INSTRUCTIONS
Important Safety Instructions
READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
BEFORE USING THIS HUMIDIFIER
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND INJURY
TO PEOPLE, INCLUDING THE FOLLOWING:
The following accessories work great with your humidifier:
Accessories
Vicks VapoPads
®
(One Menthol VapoPad Sample Included)
Menthol scent: VSP-19, VSP19FP, VSP19VPC or VSP-19-CAN
Lavender/rosemary scent: VBR-5 and VBR-5FP (US only)
Use Vicks VapoPads with your humidifier for soothing vapors.
Enjoy 8 hours of soothing comfort per pad.
Protec Antimicrobial Cleaning Products
(Protec Cleaning Ball: PC1 and PC2 or Protec Cleaning Fish: PC1F)
The Protec Cleaning Products feature an antimicrobial, Aquastat
®
, that
helps keep your humidifier cleaner, longer. Simply drop in the tank for
fresh, clean mist! Benefits of using these products include:
• Kill up to 99% of odor causing bacteria
• Keep cleaning for 30 days
• Contain no harmful chemicals
Protec
®
Demineralization Cartridge (included in some models)
(TWT500)
This humidifier works with a Demineralization Cartridge that helps remove
minerals from the water. This helps prevent the build up of minerals
(“white dust”) that can occur in hard water areas. If you live in a hard water
area, we recommend the use of this demineralization cartridge if not using
distilled water. For best results, replace your Demineralization Cartridge every
20-30 fillings, or when you begin to notice white dust forming. The effective
time will vary depending on the mineral content of the water used.
Humidity Monitor
(V70 or V70-CAN)
Displays relative humidity and room temperature so you can maintain
a comfortable humidity level in your home. The ideal humidity level
is between 40-60%.
Accessories available at retailers and at www.vickshumidifiers.com.
4
5
Keep this instruction manual for reference.
1.
Remove packaging materials. Locate
Float Paddle
and set aside. This is required for operation.
2.
Locate the Demineralization Cartridge (included in some models) and set aside. This is
optional for operation.
3.
Remove twist tie and extend power cord. Place on a firm, level, water resistant surface
a minimum of 12 inches (30 cm) from walls.
Float Paddle Installation – required for humidifier to operate
1.
Remove Water Tank.
2.
Line up Float Paddle with the float paddle shape on the bottom of the Reservoir.
3.
Place Float Rod over both Brackets and press firmly until you hear it click into both Brackets.
4.
Pull gently up on the Float Rod to be sure it doesn’t pop out of the Brackets.
5.
Replace Tank in Base.
If using the optional demineralization cartridge, see next section
Installing Demineralization Cartridge
.
This humidifier uses a float system to regulate the water flow from the Tank to the Reservoir. The Float
Paddle must be properly installed for the unit to operate. If not properly installed, water may not flow into
the Reservoir or it may leak from the Base. The Float Paddle is designed to be easy to install and remove.
CAUTION:
Improper placement of the Float Paddle could result in leaking or water
not feeding to the Reservoir.
Step 2
Step 3
Step 1
Setting Up Your Humidifier
Unpack the Humidifier
Setting Up Your Humidifier
(Continued)
To
p
Le Haut
Step 2
Step 5
Step 4
MAX
MAX
Step 3
To
p
Le Haut
“Click”
MAX
MAX
Float
Rod
Float
Paddle
Brackets
Step 1
Hard Water and White Dust
High mineral content in your water, also known as hard water, may cause a white mineral residue to
accumulate on surfaces in the room near the humidifier. This mineral residue is commonly referred to
as white dust. The higher the mineral content (hardness) of your water, the greater the potential that an
ultrasonic humidifier may produce white dust.
White dust is not a result of a defect or flaw in the humidifier. It is a result of the amount of minerals
suspended in the water you are using.
14
Demineralization
Cartridge
(included in some models)
15
Plunger
16
Tank Gasket
17
Float Paddle
18
Air Outlet
19
Water Reservoir
20
Nebulizer
1
Mist Outlet
2
Outlet Cover
3
Outlet Gasket
4
Tank Handle
5
Tank Opening
6
Tank Cover
7
Water Tank
8
Auto Shut-Off Float
9
Housing
10
Base
11
Power Knob
12
Scent Pad Door
13
Mist Chamber
Components
MAX
MAX
10
1
3
2
4
9
7
6
5
15
14
12
8
18
13
20
19
17
16
11
Vicks
®
EasyFill Cool Mist Humidifier (Model VUL570)
Getting to Know Your Humidifier
How It Works
Water is released into the Reservoir when the Float Paddle engages the Plunger at the bottom of the Water
Tank. A Nebulizer vibrates at ultrasonic frequency, breaking the water into a fine mist. The mist is quietly
propelled by a fan up a vertical Mist Chamber to the Mist Outlet where the cool, visible mist enters the room.
This humidifier will shut off when the water level is low or when the tank is removed from the base.
1.
Pour cool water from a pitcher or jug directly into Water Tank.
2.
Fill to the MAX line marked on the outside of the Tank or to the MAX indicator on the
Tank Cover. Replace the Tank Cover if it was removed for filling.
Filling/Refilling The Water Tank
(Continued)
1.
Grasp Tank Handle and lift Water Tank to remove from Base. Carry Tank to sink.
2.
Fill Tank with cool water to the MAX line marked on the outside of the Tank or to the MAX
indicator on the Tank Cover. Replace the Tank Cover if it was removed.
NOTE:
The Tank should be carried using two hands; one hand on the Handle located on top of the
Tank and other hand supporting the bottom of the Tank.
3.
Carry Water Tank back to humidifier.
4.
Replace the full Tank on the Base.
CAUTION: Use care when handling Water Tank to avoid unnecessary impact. Banging
or dropping the Water Tank could result in damage to the Tank that may cause leaking.
Option 2: To Fill Tank at the Sink
Option 1: To Fill Tank at the Humidifier
This humidifier holds a maximum of 1.25 gallons (4.7 liters) of water.
The Tank Cover is removable. You can fill the Tank with the Cover in place or with the Cover removed.
Be sure to replace the Cover before using the humidifier to keep objects and debris out of the water.
The Tank can be filled in two ways:
Option 1: At the Humidifier Option 2: At the Sink
Both filling options can be performed with or without the Tank Cover in place.
Note:
Ensure the Float Paddle has been placed correctly in the Reservoir before filling.
See
Float Paddle Installation
instructions if necessary
Manufacturer will not accept responsibility for property damage caused by water spillage.
MAX
MAX
6
7
Step 2
Step 3
Step 1
Step 2
Step 2
Step 3
Step 4
Step 1
Step 1
Installing the Demineralization Cartridge - (Optional)
If you live in a hard water area, the use of distilled water or a demineralization cartridge with tap water
will help minimize the production of white dust. A Protec Demineralization Cartridge (Model # TWT500)
is included in some models. To install it:
1.
Remove
Tank
Cover.
2.
Press the Cartridge into the recessed area inside the Water Tank and twist to secure.
3.
Fill Tank with water according to instructions in the next section,
Filling/Refilling the Water Tank
.
Note:
With a new, dry cartridge, there may be a delay of a few minutes while the water begins to
pass through the cartridge.
For best results, replace your Demineralization Cartridge every 20-30 fillings, or when you begin
to notice white dust forming. For your convenience, write the month and day you installed the new
cartridge on the top with a permanent marker.
To replace, twist the Cartridge and lift to remove. Dispose of in household trash. Replace with a new
Protec Demineralization Cartridge (Model # TWT500). (Not available in Canada).
Filling/Refilling the Water Tank
Setting Up Your Humidifier
(Continued)
MAX
MAX
Option 1
MAX
Option 2
MAX
MAX
MAX
MAX
MA
X
MAX
M
AX
