4
Directions for Use:
1.
Tear scent pad pouch at notch to expose pad.
DO NOT
touch exposed pad directly. If
you do touch pad, be sure to wash hands thoroughly.
2.
Slide side tabs up to furthest position.
3.
Insert 1 or 2 VapoPads into the top slots of the Advanced Waterless Vaporizer. Insert
scent pad with angled side facing downward into the scent pad slot. Using the side tabs
slide the VapoPad down into the unit.
4.
Vapor intensity can be controlled by sliding side tabs up or down. The further down,
the softer the vapor release intensity. The higher up, the stronger the vapor release
intensity.
5.
Plug the Advanced Waterless Vaporizer directly into a 120V electrical wall outlet.
6.
Replace pads after 8 hours on high, 12 hours on medium, 16 hours on low.
Nightlight Control:
The nightlight is always on when unit is plugged into a wall outlet. Nightlight brightness can
be controlled by sliding shield over light.
Replacing Pads:
1.
Unplug the Advanced Waterless Vaporizer.
2.
Slide side tabs to highest position to expose VapoPads.
3.
Gently shake or pull out used VapoPads and discard.
4.
Open refill VapoPads and insert as described above.
Cleaning instructions:
If there is any residue from VapoPads built up on the unit, unplug the unit and wipe clean
with a dry cloth.
DO NOT
use any household cleaners and
DO NOT
immerse in water to clean.
DO NOT
use any other pads or oils with the Vicks Advanced Waterless Vaporizer.
DO NOT
place more than one pad in each slot. A light layer of oil may form on the Advanced
Waterless Vaporizer. Should this occur, unplug the unit and wipe with a dry cloth.
