VibroSystM LIN-300 Series, Installation Manual

Page: 27 / 40

Copyright © VibroSystM Inc., 2010
27 LIN-300 Protection Boxes_Installation - Rev. 0
O
Mounting a protection box on the stator
or machine casing:
1. Drill (refer to Figure 17 : “Mounting holes
location ” ) and thread into the structure
(refer to Figure 18 : “Fastening the
protection box on steel” ).
2. Fasten the protection box as shown.
Figure 18 : Fastening the protection box on steel
Mounting a protection box on concrete:
1. Drill into the concrete wall (refer to
Figure 17 : “Mounting holes location ” )
and set the anchor bolts with the special
punch (refer to
Figure 20 : “Punch for
concrete anchors” ).
2. Fasten the metal protection box as
shown (refer to Figure 19 : “Fastening
the protection box on concrete” ).
Figure 19 : Fastening the protection box on concrete